This fun card uses an awesome technique that allows you to get maximum results from a paper pack or 12x12 sheet of paper. Cut your 12x12 sheet into 9 4"x4" squares. Then layer two of the squares (opposite patterns up) and cut both at the same time at an angle (either direction). Then match the top of one square with the bottom of the other. Once matched, then adhere on half at the top of the card front (3 sides equal) and the other at the bottom of the card front (3 sides equal) this leaves a gap between the two. I layered my pieces on a Whisper White piece that is 4" wide x 5 1/4" high. This gave me a white gap between the pieces. I stamped the greeting and confetti as desired. Then I used two strips of coordinating scrap cardstock that were longer than needed. After I adhered them to the cover the seams, I trim them to width. Finish up with embellishments as desired.
22 May 16